Make your own free website on Tripod.com
Roll Tank Deck System - Beam 1
By:Joe Bousquet

Introduction
Before
Destruction
Bulkheads
Beams 1
Beams 2
Roll Tank 1
Roll Tank 2
Roll Tank 3
Deck 1
Deck 2
Finish N Fit
Gone Sailing

b12: The gunwales were glued in pieces onto the inside edge of the hull. b11: The gunwales are complete and planed flat aft of the foredeck and angled to the camber of the foredeck near the bow.
b14: The foredeck support beams: a set going to the chainplates and a set going forward, all terminating at the mast post. A centerline stringer from the stem to the top of the foredeck. b15: A close up view of the compression beam from the mast post to the chainplate. The plywood brace helps to tie the beam to the hull. It's cutout allows the chainplate bolts to accept nuts and washers.



Joe Bousquet - jbousquet@erols.com